IP113A/B LF not only supports store and forward mode, it also supports modified cut through mode and pure converter mode for low latency data forwarding.
IP804A meets all IEEE 802.3AF-2003 requirements, such as multi-point resistor detection, PD classification, DC Disconnect, and Back-off for Midcap.
IP802AR meets all IEEE 802.3AF-2003 requirements, such as multi-point resistor detection, PD classification, DC Disconnect, and Back-off for Midcap.
IP1001C supports TP and Fiber auto selection, TTL level signal for SD detection, WOL, and Green Power.
IP108A can be programmed to operate in various modes through either hardware (hardware strapping pin) or software control (registers setting via SMI).
IP101G is designed to use category 5 unshielded twisted-pair cable or Fiber-Optic cables connecting to other LAN devices.
8 Port PSE Controller
4 Port PSE Controller
4 Port PSE Controller
2 Port PSE Controller
24 Port FE + 5 Port Gigabit Ethernet Switch
24 Port FE + 5 Port Gigabit Ethernet Switch
24 Port FE + 2 Port Gigabit Ethernet Switch
16 Port FE + 3 Port Gigabit Ethernet Switch
16 Port FE + 3 Port Gigabit Ethernet Switch
16 Port FE + 2 Port Gigabit Ethernet Switch
8 Port FE + 2 Port Gigabit Ethernet Switch
8 Port FE + 2 Port Gigabit Ethernet Switch
17 Port FE Ethernet Switch
9 Port FE Ethernet Switch
9 Port FE Ethernet Switch
9 Port FE Ethernet Switch
9 Port FE Ethernet Switch
8 Port FE Ethernet Switch
